If you have any new Burton binding using the newest ReFlex baseplates and need to mount them to that Burton Channel snowboard then these are the discs you need. You can tell what bindings you have in a couple of ways and the easiest is to look at the underneath of the binding and look for the word ReFlex. It is that simple. Another more subtle way is to look at the hole in the binding baseplate and see if it has small teeth on the edges of the hole that would match the teeth on the edges of these discs which are pretty obvious in the picture here.
Check this out Snowboarders. These discs are unique in that they come standard with the Burton Youth ReFlex bindings but work with all the Adult ReFlex bindings. These have both The Channel and 4x4 hole patterns on one ReFlex disc. What this means is that you can adjust your stance width using the disc on a 4X4 hole pattern board. This means you do not have any edge to edge, I.E. toe / heel overhang adjustment with your bindings BUT you do have more stance width adjustment. If you are less concerned about toe or heel overhang or your boot fits perfectly using the center holes on a standard disc then this disc will allow you to dial in your width almost perfectly.
- 1 pair of discs, no hardware (screws or washers)
- Works on 4 hole pattern boards
- Works on Burton Channel boards
- Use with M6 X 13mm Burton hardware on Channel boards
- Use with M6 X 16mm Burton hardware on standard 4x4 boards
Need screws for those discs to attach to your board. Follow link below.
Burton has gone through a few variations of plates and discs over the years for their 3 hole pattern (3D), 4 hole pattern, The Channel System Generation 1 and Generation 2, ReFlex bindings and their older Non ReFlex bindings. If you are not sure what you need email or give us a call and we will hook you up. If you are emailing us please send pictures of your bindings and board. This always makes it easier for us to get you exactly what you need.